Eagle Tool US ET18721 monteringsboreskaft, brugt med udskiftelige afbryderbitshoveder, 3/16-tommer gange 21-tommer, fremstillet i USA 3/16 in. 21 tommer.

Name: Eagle Tool US ET18721 monteringsboreskaft, brugt med udskiftelige afbryderbitshoveder, 3/16-tommer gange 21-tommer, fremstillet i USA 3/16 in. 21 tommer.
Brand: Eagle Tool US
SKU: 0850078004116
Price: 319.56 DKK
Availability: InStock

Brand:Eagle Tool US

3.9/5

kr
319.56

Eagle Tool individuelt størrelse, fleksible fjederstålskafter. Fleksible fjederstålskafter kommer med fiskeoptagelseshuller, tre flade, skridsikre spændegreb og et skridsikkert slebet hak til det udskiftelige hoved. Trådfiskehul i borepatronenden. Skaftet måler 3/16-inch diameter ved 21-inch længde.

Beløb

Tilføj til kurv Køb nu

EAN: 0850078004116

Kategorier Værktøj og boligforbedring, Værktøj & Håndværktøj, Elektroværktøjsdele og tilbehør, Elektrisk boremaskine dele & tilbehør, Bor Bits, Installatørbor,

Udskiftelig sætskrue og unbrakonøglesæt ETAKIT2. Trådfiskehul i borepatronenden. Skridsikker fladt (boreende) og skridsikkert tre fladt greb (patronende). Fleksibelt fjederstålskaft. Til brug med hoveder ETS375, ETS562, ETH375, ETM375 og forlængeradapter ETHXKIT187.

Brand	Eagle Tool US
Country of Origin	USA
Cutting Angle String	135 Degrees
Domestic Shipping	Item can be shipped within U.S.
Finish Type	Black Oxide
International Shipping	This item can be shipped to select countries outside of the U.S.
Item model number	ET18721
Manufacturer	Eagle Tool US
Material	Alloy Steel
Shank Type	Round

5 Star

4 Star

3 Star

2 Star

1 Star

Skriv din anmeldelse

Din e-mail vil ikke blive offentliggjort. Alle obligatoriske felter er markeret med^*

Din vurdering

Scritto da: Amazon Customer

Much better than single piece design

I have a business that provides low-voltage installation services. I greatly prefer an interchangeable setup like this over single piece (bit plus shaft design). With the single piece once you dull the bit you have to replace the entire thing (at $30-50 a pop), not to mention you end up needing 4-8 different bits to accommodate different drill bit sizes and lengths. It is easy to attach a new bit and the lip design helps prevent the bit from spinning loosely. The reason for 4 stars is because you have to really make sure to get the screws tight on this otherwise you end up with a bit stuck inside the wall. FYI the 90 degrees is for the entire length of the rod, dont expect to make a 1" hole and bend this at a sharp 90 degree angle. Also the larger the drill bit the slower you should go with your drill. If you try to push a 3/4" bit through a double 2x4 header at max speed you will likely break the rod before you drill through.

Scritto da: Jarrod Major

A decent size for those hard-to-reach places

Pretty simple tool, not much to say, it does the job. 1/4" shank is very rigid. Like the convenient hole on the drill side for wire pulls.